Tel No. (+86) 371-55629010

Steam Boiler Supplier 4t Uzbekistan

Industrial boilers and gas condensate natural gas hazard industrial boilers produce condensate water hazards 1, the corrosion of condensate water boiler heating surface of the main hazards to the natural gas industry is a corrosive effect on the boiler heating surface of the boiler. Condensate corrosion WNS rear of the boiler heating surface of the bottom of the tube focus, mainly iron oxide corrosion products. Condensate corrosion can cause intense side wall thinning, strength weakened. (1) condensation with the flue gas evolution corrosion, some CO2 is dissolved in the condensed water, CO2 generated in case of weak electrolyte H2O H2CO3, ionized hydrogen ions, so that a weak acid condensate, and another part of the nitrogen oxides and containing a very small amount of sulfur dioxide dissolved in the condensate, enhances the acidity of the condensate, the pH of the condensed water as in table 1 were lower than the position of the drum 4.3. iron hydrogen evolution corrosion can occur in the acidic solution, and the strong acid, the reaction The faster rate. (2) Since the oxygen etching gas during combustion boiler need to ensure a certain air ratio, combustion flue gas contains oxygen. When the steam condenses, some oxygen will be dissolved in the condensed water, causing corrosion of the metal heating surface of the oxygen. 2, when the cross-sectional area to reduce the flue gas flow type gas boiler industrial boilers operate at low load, the heated surface of the flue gas, the condensed water gathered in the smoke tube, the resulting corrosion products accumulate in the bottom of the tube, even clogging of the pipe part, thus reducing the flow area of ​​the flue gas, the flue gas resistance increases, and increase in power consumption of the blower. 3, the furnace temperature is lowered, damage to the burner within the examination of natural gas in industrial boilers, often find a certain amount of condensed water. We found condensate discharge tube boiler such severe congestion, resulting in condensed water in the lower furnace does not discharge, and refluxed for aggregation. When the boiler is started, the heat accumulated in the furnace absorbs the condensed water and evaporated fuel combustion, thereby reducing the furnace temperature. If the furnace condensate accumulated too much, and even dipped into the burner, causing damage to the burner. Suddenly turn off the boiler, the boiler does not start, because the burner too much condensation water immersion, affecting the safe operation of the boiler. 4. Effect of boiler condensate generated on the heat sealing material penetrates into the sealing material of the boiler insulation, the point of the arrow indicated gas tank gas boiler WNS industrial boilers. Sealing condensed water immersion insulation material for a long time, the insulation effect will be weakened or even physical damage, increased heat loss. Meanwhile, the condensed water will make the sealing material deformation aging, sealing capability weakened, leading to a certain amount of flue gas emissions, which not only be dangerous, can also cause a certain amount of heat loss.

Currently, the use of better gas boiler low NOx combustion technology has premix, FGR two kinds.

First, the premix combustion technology

Six Product Features of Oil-fired Boiler

Three-way structure: adopt the international popular boiler shell type three-way structure, all wet back structure, combustion chamber large volume design, make the combustion fuller. The fuel is combusted under slight positive pressure in the hearth, and the high-temperature flue gas turns 180 °backward along the tank through the reburning chamber, 180 °into the first flue bundle, 180 °through the compressed front chamber, and then into the second tube bundle, after convection heat transfer, it is discharged into the atmosphere.

New R & D building fast-party group, is a technology demonstration, research and development as an integrated office building. On the first floor exhibition hall design is simple and modern technology, integration of human-computer interaction, virtual reality, projection, graphic panels, simulation models and other advanced means of interactive multimedia display a variety of boiler technology, creating a precedent for the domestic boiler industry technology show. 360 holographic ---- wing tube interactive rejection screen technology - condensing technology Slide TV - premix --FGR intelligent human-computer interaction technology modeling techniques - Remote monitoring