Tel No. (+86) 371-55629010

Supplier Boiler Machine 1t Russia

Inside the Fangkuai supplier boiler machine 1t russia plant, there is a special corrugated furnace bladder production line, which can be processed according to the computer setting mode. At the same time, this is also a unique processing technology of Fangkuai Boiler. The cost of natural gas fuel alone exceeds 5 million yuan per year. The corrugated furnace liner fired by this production line can not only increase the heating surface of the boiler, but also alleviate the damage caused by the thermal expansion and contraction to the combustion chamber, and greatly extend the service life of the boiler.

First, there is the stage, supplier boiler machine 1t russia water treatment problems

1. The lack of attention to the work of boiler water treatment

Periodic operation of supplier boiler machine 1t russia blowdown requirements a) to be performed when the boiler discharge pressure or low fire load, and should be stopped short; b) To the sewage before the boiler water level is raised to close the upper limit of normal level, the sewage water level to closely monitor, prevent boiler water; c) operates the drain valve, and if it can not be directly observed when the water level of the water level gauge. Water level monitoring personnel should contact the joint sewage; d) must discharge once every eight hours. If a common multiple boiler blowdown manifold, each boiler and the check valve when the outfall nor prohibited while sewage; E) for other operations not sewage, if necessary to perform other operations, stop sewage; f) when the sewage, first slowly open the valve opening closer to the boiler, and then intermittently opening and closing the valve opening away from the boiler quick, rapid discharge. After discharge, quick opening valve is closed first, and then slowly open valve closed, and then open the valve slightly open fast, close the water discharge after exhausted; End g) discharge operation, the discharge valve is closed, should be checked to confirm no sewage pipe outlet leakage.

Natural gas industrial supplier boiler machine 1t russias produce condensate water hazards natural gas industrial boilers produce condensate water hazards natural gas industrial boilers produce condensate water hazards 1, the corrosion of condensate water boiler heating surface major harm to the natural gas industrial boilers is the corrosive effect on the heating surface of the boiler. Condensate corrosion WNS rear of the boiler heating surface of the bottom of the tube focus, mainly iron oxide corrosion products. Condensate corrosion can cause intense side wall thinning, strength weakened. (1) condensation with the flue gas evolution corrosion, some CO2 is dissolved in the condensed water, CO2 generated in case of weak electrolyte H2O H2CO3, ionized hydrogen ions, so that a weak acid condensate, and another part of the nitrogen oxides and containing a very small amount of sulfur dioxide dissolved in the condensate, enhances the acidity of the condensate, the pH of the condensed water as in table 1 were lower than the position of the drum 4.3. iron hydrogen evolution corrosion can occur in the acidic solution, and the strong acid, the reaction The faster rate. (2) Since the oxygen etching gas during combustion boiler need to ensure a certain air ratio, combustion flue gas contains oxygen. When the steam condenses, some oxygen will be dissolved in the condensed water, causing corrosion of the metal heating surface of the oxygen. 2, when the cross-sectional area to reduce the flue gas flow type gas boiler industrial boilers operate at low load, the heated surface of the flue gas, the condensed water gathered in the smoke tube, the resulting corrosion products accumulate in the bottom of the tube, even clogging of the pipe part, thus reducing the flow area of ​​the flue gas, the flue gas resistance increases, and increase in power consumption of the blower. 3, the furnace temperature is lowered, damage to the burner within the examination of natural gas in industrial boilers, often find a certain amount of condensed water. We found condensate discharge tube boiler such severe congestion, resulting in condensed water in the lower furnace does not discharge, and refluxed for aggregation. When the boiler is started, the heat accumulated in the furnace absorbs the condensed water and evaporated fuel combustion, thereby reducing the furnace temperature. If the furnace condensate accumulated too much, and even dipped into the burner, causing damage to the burner. Suddenly turn off the boiler, the boiler does not start, because the burner too much condensation water immersion, affecting the safe operation of the boiler. 4. Effect of boiler condensate generated on the heat sealing material penetrates into the sealing material of the boiler insulation, the point of the arrow indicated gas tank gas boiler WNS industrial boilers. Sealing condensed water immersion insulation material for a long time, the insulation effect will be weakened or even physical damage, increased heat loss. Meanwhile, the condensed water will make the sealing material deformation aging, sealing capability weakened, leading to a certain amount of flue gas emissions, which not only be dangerous, can also cause a certain amount of heat loss.