When using the longer shutdown maintenance method. This is done; pot of water put the net after shutdown, residual heat boiler using a drying furnace, timely removal of residual scale and pot residue was then placed on the tray containing a desiccant within the drum and grate, Finally, close all valves, manhole and hand hole door. Regular inspection and maintenance, and timely replacement of the desiccant failure.
In recent years, the state environmental protection is all the more attention we as a company with the times, in order to respond positively to the implementation of the national environmental protection requirements from coal to gas project. But the choice of boiler suppliers in this area quite a headache, after repeated comparison and investigation, we chose to partner with fast boiler. Fang did not disappoint quickly proved that the recommended boiler operation after use to fully meet our needs, both energy saving and environmental protection, high thermal efficiency, to a certain extent, cost savings for our fuel. --customer feedback
When the condensing boiler is used, it adopts a special principle to make use of the way of water circulation to produce a certain heat exchange so as to achieve the desired purpose. Although the price of the integrated condensing boiler will not be too high, and the operation is very simple, and has good safety performance and so on, but in the process of operation, it is necessary to pay attention to the following points.
1, pre-service preparations for long-term non-operational or brand-new fully premixed condensing boilers, clean up the system with water before starting again, this is an extremely important preparatory work for condensing boilers. The operation of the docking will be of great help. And condensing boiler manufacturers remind you to start in the correct order, such as turning the circulating pump on before you can ignite it.
2, in order to control the details of the operation of the condensing boiler during its operation, in order to make it work better, the pressure in the boiler should always be in a stable state, and the temperature in the boiler should be controlled. Therefore, at any time to monitor and monitor the discovery of any changes should be made certain adjustments. And condensing boiler manufacturers emphasize that the gas in the pipe network should be discharged from time to time, which can prevent vaporization well, at the same time, it should be carried out regularly and the quantity of water in the pipe network should be reasonably distributed.
3, to control the pressure in the boiler well, if the pressure inside the boiler suddenly rises very high during the use of the fully premixed aluminum condensing boiler, it should be immediately found out the cause, usually because the water temperature is too high for gasification. Therefore, the water temperature should be properly lowered to solve this problem. It is also possible that clogging occurs because the dirt in it has not been cleaned up, so the cleanup should be done in a timely manner. If, however, the pressure of the condensing boiler is suddenly reduced, the boiler should be rehydrated in a timely manner, as this is mainly due to the shortage of water.
Globally, waste disposal is definitely a headache for all countries. Every year, the amount of municipal solid waste generated by various reasons is huge. Generally, most of these garbage will be treated by incineration, which also causes many problems such as the generation of a large amount of harmful gases. The development of waste incineration waste heat boilers has played a good role in solving this problem. According to the characteristics of the garbage treatment process, the waste heat boiler produced by ZG boiler has a very important role in preventing the formation of harmful substances of dioxins. At the same time, the waste heat boiler has good adaptability to waste incineration flue gas and has excellent economic performance.