Tel No. (+86) 371-55629010

biomass boiler industries usa

Meanwhile, the transformation of the cost of coal-fired biomass boiler industries usas, specifically how much, is based on the actual situation of the boiler to set, refer to the following main points.

1, determine the status of the boiler: To understand the current situation in the use of coal-fired boilers, there is almost a new, how about the extent of damage, if there is severe wear.

2, the transformation method: There are many ways of coal-fired boiler, the coal to gas, biomass, coal, coal to methanol to change the status quo are more and more. How you want to change, only partial or total transformation of the transformation, these costs are different.

3, difficult transformation: some boiler design of structural change is better, but some difficult to change the degree of difficulty of the transformation is the technical difficulty of the transformation will affect the final cost.

4, boiler life: life is generally coal-fired boilers in 10 years --20 years, if the stove has been used for more than six years, the extent of the damage is more severe, corresponding to the degree of difficulty and the transformation will also increase the .

Coal-fired biomass boiler industries usas to gas boilers benefits and precautions With the rapid development of national energy-saving environmental protection, the traditional coal-fired boiler can not meet the needs of the times. Therefore, the coal-fired boiler biomass boiler or gas boiler has become in many boiler user's choice. Before the transformation, to understand the difference between .1 and gas boiler fired boiler. Circulating fluidized bed combustion boiler fired by coal crushing device fluidized combustion process, the coal by crushing device percutaneously into the bunker through a the spreading coal coal injecting air into the furnace; circulating ash by heating, fluidized combustion process. When the coal into a gas fuel is injected directly into the combustor for combustion. 2. Combustion of Coal is mainly composed of C, H, O, N, S, ash and moisture and other elements. Generated when coal SO2, SO3, NOx ash and moisture, and SO2, SO3, NOx from flue gas emitted into the atmosphere, pollute the environment and cause harm to humans. The main components of the exhaust gas and coke are CO and H2. The main produce CO2 and H2 post-combustion, much lower than coal-fired boiler SO2, SO3 and NOX emissions. 3. Ventilation pressurized combustion coal combustion boiler used in a combustion mode. The bottom of the combustion process through the induced draft fan with fan and completed. In the combustion of coal, it requires a lot of air. Gas under a slight positive pressure in the boiler or burner slightly negative pressure, which requires less airflow. Burner air may be pre-mixed with natural gas. 4. coal boiler control reasons, material thickness, amount of wind, the wind volume, wind and other than coal, coal-fired boiler is difficult to automatically adjust the operating parameters of the boiler according to the load. However, fewer factors gas boiler, the burner valve can be adjusted according to the size of the load, easy to implement automatic control. Coal-fired boiler to a gas boiler Notes: Main results are as follows: (1) small boiler, the coal-fired boiler to a gas boiler, i.e. the negative pressure of combustion from the original to the current combustion slight positive pressure, and must pay attention to the furnace wall structure sealing problems. Closely related (2) selection and arrangement of the burner and furnace, the degree of filling of the flame in the furnace is preferably not formed dead air, to avoid the interference of adjacent flame burners, to avoid interference from adjacent burner flame. Unburned gas - air mixture should not be in contact with a heated surface, in order to avoid incomplete combustion. Gas combustion. Gas burner arrangement disposed conduit and ducts should be considered reasonable gas pipe and duct arrangement, ease of operation, inspection and maintenance. (3) the transformation of coal-fired boilers is mechanized layered gas boiler should be removed before the arch and the arch, and the bottom heating surface increases, in place of the grate, the grate to prevent overheating. Gas Velocity (4) on heat transfer surface of the fly ash is not restricted abrasion conditions, convection heating surface heat transfer coefficient is increased, increasing the pressure in the boiler where H is unduly increased. Boiler erosion surface. At this time, the capacity of the boiler should be noted that the steam separator to ensure the quality of the steam.

Palm kernel shell fired biomass boiler industries usa for sale supplied by ZBG is a type of biomass fired boiler which mainly takes palm kernel shell as its fuels and palm kernel shells (or PKS) are the shell fractions left after the nut has been removed after crushing in the Palm Oil mill. Kernel shells are a fibrous material and can be easily handled in bulk directly from the product line to the end use. Large and small shell fractions are mixed with dust-like fractions and small fibres. ZG Boiler is the palm kernel shell fired boiler manufacturer in China with more than 70 years’ history and we have identified ASME and IBR certificates which are our guarantee to supply customers products with advanced technology, high quality, excellent service.

Fang fast Euromonitor θ5 completely resolved from the source temperature condensate waste problem, based on the paper packaging industry production line features bold and innovative in design and condensing technology biomass boiler industries usas, reducing operating costs for the industry, reduce energy consumption, is a paper packaging business boiler replacement product of choice.