Tel No. (+86) 371-55629010

0.7mw-70mw ce approved coal hot water boiler

Our horizontal CFB steam boiler for sale has various types: coal fired CFB steam boiler, biomass fired CFB steam boiler. This basic mode of operation is found in most every steam boiler, but there are a few modifications that have been created for different purposes. A superheated boiler takes the standard process and further heats the steam, increasing the temperature and energy output, and it commonly is used to rotate large turbines. Water tube boilers replace the large tank with a series of water-filled tubes that can reach boiling faster and give off more steam.

The method of adjusting the temperature of the superheated steam heating stove have? The method of adjusting the temperature of the superheated steam heating stove have? DC boiler steam temperature is mainly adjusted by adjusting the quantity of fuel to water. In actual operation, because the efficiency of boiler feed water and fuel heat enthalpy (depends on the water temperature) and the like will change, so the actual boiler operation to ensure the water-fuel ratio of the exact value is not easy. Coal-fired furnace will fluctuate because of the amount of coal and the amount of fuel due to the steam temperature. So, except DC boiler fuel to water ratio as the coarse adjustment means, but also must be used as a method of spray desuperheater means of fine-tuning adjustment. There is also some boiler flue gas recirculation, dampers and methods of the swing center of the flame as an auxiliary adjusting device.

In October 2016, my company and the China Dunhuang International Hotel signed a ZWNSL2.1-1.0 / W-Y.Q vacuum condensing gas 0.7mw-70mw ce approved coal hot water boiler to provide heating and hot water for the hotel. The boiler implementing the response to the national policy of environmental protection requirements and local environmental protection departments on a series of low nitrogen emission standard boiler requirements, in terms of design, manufacture, installation and other sectors have strict checks to ensure that the boiler safe and stable operation.

Strengthen the daily management and maintenance of boiler equipment during 0.7mw-70mw ce approved coal hot water boiler operation, the operator must follow the norms and requirements of the hot water boiler equipment, and regularly pan) furnace equipment inspection and maintenance, identify problems in time, mainly on the following aspects of inspection and maintenance: the construction of combustion equipment, if the middle grate to check for breaks, is off the grate, blowing the door to work, regular cleaning of existing combustion equipment coal ash and coal leakage, so as not to be grate jacking or blockage; check the furnace, flue ash doors, fire tube end hole, whether there is economizer leakage phenomenon, if the air leakage phenomenon, immediate repair; check valve, the pump, the valve stem is loose; squeeze water pressure gauge, safety valve if there is corrosion phenomena if repair or replaced immediately rust; regular inspection blower, fan and rotating equipment, to ensure clean these devices, during operation of the device bearing temperature should not exceed 40 ℃, the oil level in the bearing housing in two-thirds of the height of the bearing shell, if less than this height, it needs time to add Net qualified new oil; water treatment equipment regularly checked to see whether the boiler water boiler water quality standards and requirements for equipment operation, if it does not want to analyze the causes of excessive water.