In recent years, the climbing oil and natural gas prices and growing demands for cleaner and renewable energy sources have inspired many boiler manufacturers to put a fresh spin on the use of biomass boiler to generate steam and heat. ZG as a manufacturer of biomass fired boiler has made efforts to design the DZL biomass fired boiler.
First Affiliated Hospital of Bengbu Medical College, responsible for staff to feedback to our company, this boiler to use less smoke production, in line with the special requirements of the hospital surroundings and national requirements for flue gas emissions. During the boiler installation and operation, square quick technical staff also always concerned about the dynamic boiler, parties can feel really real fast customer service, using fast boiler is assured. --customer feedback
The scaling of gas-fired 1t steam boiler russia not only reduces the thermal efficiency of the boiler, but also increases the temperature of the heating surface of the boiler, causes damage to the heating surface, and even causes the explosion accident of the boiler. Therefore, the use of soft water treatment equipment, strictly according to the process operation of boiler feed water softening treatment equipment, control boiler feed water quality, can delay the formation of the scale. At the same time, it is very important to control the boiler scale in real time, master the boiler scale and clean the scale if necessary. Because the temperature of the gas-steam boiler body and the steam-water heat pipe system is higher than the air temperature in the boiler room, some of the heat is emitted through radiation and convection into the surrounding air. This becomes a loss of heat. Boiler Therefore, the heat loss should be reduced when the heat insulation and heat pipe system of the boiler are damaged or leakage is discovered. The increase in noise from gas-fired steam boiler burners is mainly due to the closure of the valve or insufficient oil intake in the oil path, blockage of the oil filter, or because of low inlet temperature, high viscosity or oil on the pump. Too high temperature; oil pump failure; fan motor bearing damage; due to dirty turbine impeller, the equipment is too loud. This failure occurs when a gas-fired boiler is in use and is not easy to atomize (heavy oil) because of the high viscosity of the oil; it is also due to cyclone and jet The distance between the nozzles is inappropriate; in addition, because the burner is worn or dirty; it is also due to the excessive heating temperature of the spare fuel tank, resulting in steam pumping the oil pump out of the oil pump; or because the oil in the oil boiler is hydrated. Gas steam boiler feed water contains a variety of impurities and calcium, magnesium and other scaling substances, the boiler will inevitably expand. The thermal conductivity of the scale is very low, so once the surface is polluted by the hot surface, the exhaust temperature of the boiler will increase, and the heat loss of the exhaust gas will increase due to the increase of the thermal resistance. The experimental data show that the heat loss of waste gas will be increased by about 2%-4% when 1mm oxide is formed on the heating surface of boiler. The thicker the scale on the heating surface of the boiler, the greater the thermal resistance, and the lower the thermal efficiency of the boiler.
Gas-fired 1t steam boiler russia will need to follow those steps: Due to the special nature of dual-use oil and gas boilers, thereby preparing the initial installation and construction from its long-term project to the acceptance stage there will be any problem to pay attention to the need to comply with, what does? Gas-fired steam boiler needs to follow the procedure step by step to complete. In this process, the need to comply with, what does? Boiler installation and construction of oil and gas dual front, first in accordance with the procedures to handle boiler installation approval procedures, pending approval of Quality and Technical Supervision after!