Tel No. (+86) 371-55629010

Coal Steam Boilergenerator

The basic configuration of the heat of the gas coal steam boilergenerator steam boiler and service method is natural gas, liquefied petroleum gas, fuel gas such as city gas as fuel, the combustion in the furnace released heated pot water, and allowed to vaporize into steam heat conversion equipment. Water in the pot is continuously released from the combustion of a gaseous fuel energy to heat the furnace, raising the temperature and generating steam under pressure, since the boiling point of water with elevated pressure is raised, the pot is sealed, the expansion of the water vapor inside limited dynamic pressure generated heat is formed as an energy source is widely used. Steam boiler fuel burn-up and to ensure that the flue gas outlet temperature was cooled to a safe value convection heating surface of the work; using the heat of the flue boiler feedwater heating, in order to reduce exhaust gas temperature, fuel economy and functions. Each steam generator heating surface and joined together and water wall tubes and other components decreased water circulation circuit. Soda storage drum, can adapt to changes in load, with internal steam separator means to ensure the quality of soft drinks, no DC boiler drum. Gas steam boiler feed water must go through qualifying process, which is to extend the life of the boiler, ensure the safe operation of the important issues. Water temperature should be close to the furnace temperature. Must regularly inspect the low water cutoff maintenance and cleaning. Water Level Controller cleaned at least once a month, rinse water table at least once a day. Rinse water table should be at the highest level; after flushing the water level should not be less than the minimum safe level, not as a net wash, can wash many times, but it must be flushed at the highest level. Require periodic sewage operation, at least once a day, after the sewage drain valve should be checked because of possible contamination and leaks; if it must be excluded. When shutdown is not maintained while the steam pressure, the steam space of the boiler will produce negative pressure air entrapment, and therefore should rise again to the fire burning total steam valve is opened.

The party soon provide us with three hot water boiler output foot, gas combustion, efficiency is very high, for us to save a lot of fuel costs. Moreover, these hot water boiler can be achieved by adjusting the full 24 hours a use hot water to meet the daily needs of old people. --customer feedback

Another technology being incorporated by boiler manufacturers is the gas turbine.When a gas turbine is used, natural gas is fired, and the hot gasses are used to spin a turbine attached to an electrical generator to make electricity.Since there is still available heat in the gas that exhausts from the turbine, it is then sent through a Utility Power HRSG (Heat Recovery Steam Generator).Similar to a watertube boiler, the hot exhaust gasses from the turbine heat water in the tubes of the utility power HRSG and turn it into steam, which is then used to turn a second steam-driven turbine attached to another electrical generator.This technology is called “Combined Cycle Cogeneration”, and is a very efficient use of fuel because the same fuel source is used twice to drive turbines.

In particular reactor is often used to complete the production process of curing material, hydrogenation, alkylation, polymerization and condensation process. Reactor for heating, cooling and gas absorption and liquid extraction processes require a physical change to using the apparatus to obtain a good stirring effect. Chemical plant reactor inseparable, many chemical plants in order to save costs, the reaction vessel of the production system to the original electric heating steam generator heating steam, nearly million annual cost savings, cost reduction for the company by Adds new efficiency initiatives.